g Consider an RAID-5 storage with 5 disk drives. A block read takes 10 time units, a block write takes 5 time units, and computing an XOR result of two blocks takes 1 time unit. Assume only one XOR operation can be performed each time (i. e., XOR operations cannot be done in parallel). A stripe (a row) has four data blocks (A, B, C, and D) and a parity block P, which are stored in the five disks, one in each disk respectively. If we need to write one data block A, give two methods to update this stripe in the RAID-5 storage. Explain each method step by step, and calculate the corresponding time cost that is needed for each method to complete the operations.

4.11 painting a wall (1) prompt the user to input integers for a wall's height and width. calculate and output the wall's area (integer). note that in this case there is a new line after each prompt. (submit for 1 point). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet (2) extend to also calculate and output the amount of paint in gallons needed to paint the wall (floating point). assume a gallon of paint covers 350 square feet. store this value in a variable. output the amount of paint needed using the %f conversion specifier. (submit for 2 points, so 3 points total). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet paint needed: 0.471429 gallons (3) extend to also calculate and output the number of 1 gallon cans needed to paint the wall. hint: use a math function to round up to the nearest gallon. (submit for 2 points, so 5 points total). enter wall height (feet): 11 enter wall width (feet): 15 wall area: 165 square feet paint needed: 0.471429 gallons

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Which of the following would not be considered a pc? a. mainframe b. desktop c. tablet pc d. laptop