a. Create the logic for a program that performs arithmetic functions. Design the program to contain two numeric variables, and prompt the user for values for the variables. Pass both variables to methods named sum() and difference(). Create the logic for the methods sum() and difference(); they compute the sum of and difference between the values of two arguments, respectively. Each method should perform the appropriate computation and display the results. b. Modify the program in Exercise1a so that the two entered values are passed to a method named getChoice(). The getChoice() method asks the user whether addition or subtraction should be performed and then passes the two values to the appropriate method, where the result is displayed

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."