Computers and Technology, 13.12.2019 06:31, Ndow2

How should you set the ohms adjust control on a multitester of analog vom, for resistance measurements?
a. by rotating the ohms adjust knob until the pointer is set over 0 volts, without shorting the test leads
b. by rotating the ohms adjust knob until the pointer is set over 0 ohms, without shorting the test leads
c. by shorting the test leads and rotating the ohms adjust knob until the pointer indicates 0 ohms
d. by shorting the test leads and rotating the ohms adjust knob until the pointer indicates 0 volts

Answers: 1

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 23.06.2019 00:00, puppylove899

Which is the correct sequence of steps to set up a document in landscape orientation? a. select page setup from the file menu. then click the margins tab and select landscape. b. select page setup from the edit menu. then click the margins tab and select landscape. c. select page setup from the insert menu. then click the margins tab and select landscape. d. select page setup from the format menu. then click the margins tab and select landscape

Answers: 1

continue

Computers and Technology, 23.06.2019 02:00, hctlawton

Which software would you use to create a print design? a. illustrator b. audacity c. reaper d. dreamweaver

Answers: 2

continue

Computers and Technology, 23.06.2019 03:00, tay9122

Jason, samantha, ravi, sheila, and ankit are preparing for an upcoming marathon. each day of the week, they run a certain number of miles and write them into a notebook. at the end of the week, they would like to know the number of miles run each day, the total miles for the week, and average miles run each day. write a program to them analyze their data. your program must contain parallel arrays: an array to store the names of the runners and a two-dimensional array of five rows and seven columns to store the number of miles run by each runner each day. furthermore, your program must contain at least the following functions: a function to read and store the runners’ names and the numbers of miles run each day; a function to find the total miles run by each runner and the average number of miles run each day; and a function to output the results. (you may assume that the input data is stored in a file and each line of data is in the following form: runnername milesday1 milesday2 milesday3 milesday4 milesday5 milesday6 milesday7.)

Answers: 3

continue

Computers and Technology, 23.06.2019 09:00, paulusl19

The first screen you see when you open word2016 what is called?

Answers: 1

continue

Do you know the correct answer?

How should you set the ohms adjust control on a multitester of analog vom, for resistance measuremen...