Computers and Technology

Adelimiter is used to do which of these?

a) separate two lines of data from each other

b) separate two fields within a line of data from each other

c) prevent autocorrection of spelling

answer
Answers: 1

Other questions on the subject: Computers and Technology

image
Computers and Technology, 21.06.2019 22:50, prettybaby406
Explain why it is reasonable to assume that receiving 3 duplicate acks in tcp is an indication that the network is not currently congested.
Answers: 1
image
Computers and Technology, 22.06.2019 15:30, DestinyK8033
Why would a programmer use the logical operator and in an if statement? a: when an action is to be taken that requires both conditions to be falseb: when an action is to be taken that requires both conditions to be truec: when an action is to be taken that requires the first condition to be falsed: when an action is to be taken that requires the second condition to be truei took the test and the answer is b.
Answers: 3
image
Computers and Technology, 22.06.2019 20:40, broang23
Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it
Answers: 2
image
Computers and Technology, 23.06.2019 19:40, Latoyajenjins1789
Use a physical stopwatch to record the length of time it takes to run the program. calculate the difference obtained by calls to the method system. currenttimemillis() just before the start of the algorithm and just after the end of the algorithm. calculate the difference obtained by calls to the method system. currenttimemillis() at the start of the program and at the end of the program so that the elapsed time includes the display of the result. use the value returned by the method system. currenttimemillis() just after the end of the algorithm as the elapsed time.
Answers: 3
Do you know the correct answer?
Adelimiter is used to do which of these?

a) separate two lines of data from each other<...

Questions in other subjects:

Konu
Biology, 04.06.2021 23:30
Konu
Mathematics, 04.06.2021 23:30
Konu
Mathematics, 04.06.2021 23:30