Microsoft excel is a application.
a. communication
b. spreadsheet
c. presentation
d. mathematical

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Why were most movies from the late 1890s until the early 1930s only filmed in black and white? there were only a few people who could afford the technology to produce color motion pictures back then. audiences did not want color motion pictures until later. the film used to make color motion pictures often overheated, which was a safety hazard, so it was generally not allowed. color films had to be hand-colored, frame by frame.

3. what is the output of the following statements? temporary object1; temporary object2("rectangle", 8.5, 5); temporary object3("circle", 6, 0); temporary object4("cylinder", 6, 3.5); cout < < fixed < < showpoint < < setprecision(2); object1.print(); object2.print(); object3.print(); object4.print(); object1.set("sphere", 4.5, 0); object1.print();