Computers and Technology, 22.02.2021 17:30, AADJ4

Ej kto mi poda numer telefonu to serduszko36puntktuw

Answers: 1

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 22.06.2019 03:10, brylove603

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it must not appear in the factorization. sample runs are given below. note that if the power of a prime is 1, then that 1 must appear in t

Answers: 3

continue

Computers and Technology, 22.06.2019 12:20, crodriguez87

Usually, when we sniff packets, we are only interested certain types of packets. we can do that by setting filters in sniffing. scapy’s filter use the bpf (berkeley packet filter) syntax; you can find the bpf manual from the internet. set the following filters and demonstrate your sniffer program again (each filter should be set separately): (a) capture only the icmp packet. (b) capture any tcp packet that comes from a particular ip and with a destination port number 23. (c) capture packets comes from or to go to a particular subnet. you can pick any subnet, such as 128.230.0.0/16; you should not pick the subnet that your vm is attached to.

Answers: 3

continue

Computers and Technology, 23.06.2019 15:30, jasssp

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Answers: 2

continue

Computers and Technology, 24.06.2019 01:10, jaileen84

Create a program that will take in a single x and y coordinate as the origin. after the input is provided, the output should be all of the coordinates (all 26 coordinates read from the “coordinates. json” file), in order of closest-to-farthest from the origin.

Answers: 1

continue

Do you know the correct answer?

Ej kto mi poda numer telefonu to serduszko36puntktuw...