Malcolm Movers charges a base rate of $200 per move plus $150 per hour and $2 per mile. Write a program named MoveEstimator that prompts a user for and accepts estimates for the number of hours for a job and the number of miles involved in the move and displays the total moving fee. For example, if 25 hours and 55 miles are input the output would be displayed as: For a move taking 25 hours and going 55 miles the estimate is $4,060.00

All of these are true about using adhesive except: a. dissimilar materials can be joined. b. mixing tips are product and material specific. c. a specific application gun may be required. d. two-part adhesives are dispensed using two mixing tips

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

1. ask the user how many questions are in the quiz. 2. ask the user to enter the key (that is, the correct answers). there should be one answer for each question in the quiz, and each answer should be an integer. e. g., 34 7 13 100 81 3 9 10 321 12 might be the key for a 10-question quiz. you will need to store the key in an array. 3. ask the user to enter the answers for the quiz to be graded. there needs to be one answer for each question. note that these answers do not need to be stored; each answer can simply be compared to the key as it is entered. 4. when the user has entered all of the answers to be graded, print the number correct and the percent correct. 5. add a loop so that the user can grade any number of quizzes with a single key. after the results have been printed for each quiz, ask "grade another quiz? (y/n)." note: you only have one array (the key). you are not creating a new key for each set of quiz answers.