Computers and Technology

Keys based on attributes that arise organically from the entity itself are referred to as what type of key? A. Natural B. Surrogate C. Primary

answer
Answers: 3

Other questions on the subject: Computers and Technology

image
Computers and Technology, 22.06.2019 20:40, broang23
Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it
Answers: 2
image
Computers and Technology, 23.06.2019 10:30, badpotterchris
How would you categorize the software that runs on mobile devices? break down these apps into at least three basic categories and give an example of each.
Answers: 1
image
Computers and Technology, 23.06.2019 11:30, leapfroggiez
Auser is given read permission to a file stored on an ntfs-formatted volume. the file is then copied to a folder on the same ntfs-formatted volume where the user has been given full control permission for that folder. when the user logs on to the computer holding the file and accesses its new location via a drive letter, what is the user's effective permission to the file? a. read b. full control c. no access d. modify e. none of the above
Answers: 1
image
Computers and Technology, 23.06.2019 19:00, amayax77
Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."
Answers: 1
Do you know the correct answer?
Keys based on attributes that arise organically from the entity itself are referred to as what type...

Questions in other subjects:

Konu
Mathematics, 31.03.2021 16:10
Konu
Mathematics, 31.03.2021 16:10