What is wrong with the following code? numl = int (input("Enter a number: "))
numz = int (input("Enter a number: "D)
num3 = int (input("Enter a number: "))
print ("The average is: + (numl + num2 + num3/3)
The last line should be print ("The average is: (numl + num2 + num/3)
The variables should be lnum, 2num, Bnum
It needs a into command
It needs a stro command

Code:

numl = int (input("Enter a number: "))

num2 = int (input("Enter a number: "))

num3 = int (input("Enter a number: "))

print ("The average is:" + ((numl + num2 + num3)/3))

It needs a str command

Explanation:

Given

The above code

Required

Determine and correct the error

At the last line of the code, there is an attempt to print the average of the three numbers.

However, this will return an error because:

In order to print the literal "The average is:" and the numeric value of (numl + num2 + num3)/3, a str command is needed.

This converts (numl + num2 + num3)/3 to a literal and then print without error.

So, the correct instruction is:

print ("The average is:" + str((numl + num2 + num3)/3))

assuming you are in the home page.

1) go to the upper right hand corner

2) click on your "profile picture"

3) go down to "edit profile"

4) it should be titled as "edit your profile", click on "profile picture"

5) choose a file

6) press "change"

you're profile picture is updated

~

solution:

this situation is called an ip conflict.

data from a server is sent in small bits called packets. in an ip conflict, some packets will end up in one computer while some other packets will end up in another computer.

so…overall none of the computers get the data as the original message or picture being sent by the server cannot be retrieved with only half the packets. so it will show up as an error.

thus the final answer is d.