Computers and Technology, 09.12.2020 06:20, QwesiElorm

Kakegurui?
anyone:D
anyone know where to get big ideas answers plz thx

Answers: 2

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 22.06.2019 02:20, eagles2286

The reset circuit used on the four 3-bit counters analyzed in this activity reset the counts to zero (000). it makes sense for the up-counters to start at zero (000), but the down-counters should start at seven (111). what would you need to change so that the 3-bit binary down counter with j/k flip-flops you just created would reset to seven (111)?

Answers: 1

continue

Computers and Technology, 22.06.2019 08:10, josued123321

Alook-up table used to convert pixel values to output values on a monitor. essentially, all pixels with a value of 190 or above are shown as white (i. e. 255), and all values with a value of 63 or less are shown as black (i. e. 0). in between the pixels are scaled so that a pixel with a value p is converted to a pixel of value 2/127 −+3969). if a pixel has a value of 170 originally, what value will be used to display the pixel on the monitor? if a value of 110 is used to display the pixel on the monitor, what was the original value of the pixel?

Answers: 1

continue

Computers and Technology, 22.06.2019 22:40, ihatemylife0

Least square fit to polynomial write a function leastsquarefit3pol that solves a linear system of equations to find a least squares fit of a third order polynomial to an experimental data set given as two row arrays. the function leastsquarefit3pol must explicitly solve a set of linear equations and cannot use polyfit. there should be no restriction on the size of the problem that can be solved.

Answers: 1

continue

Computers and Technology, 23.06.2019 09:30, cdavis379

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

continue

Do you know the correct answer?

Kakegurui?
anyone:D
anyone know where to get big ideas answers plz thx...