Which of the following is most often a barrier to software migration? It's easier to continue using an out-of-date software program as long as possible.
O It's usually cheaper to upgrade software than it is to purchase a new product.
O It's difficult to find new software that is secure enough to replace the old software.
O It's not possible to keep old data when migrating to a new software program.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Look at the far left lane in the picture. explain what the red car is doing and what it needs to do to travel safely.

Consider the following statements, then select one of the answers below: the signal() function shown below registers "sig_handler()" as the signal handler function for the sigkill signal, without the complexity of using when the sigkill signal is sent to a process running this code, by a user typing "kill -kill ", where the correct process id is used for to target the process, sig_handler() will be executed.