How can I change my IP address on a iPhone?

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

The instruction ishl (shift left integer) exists in jvm but not in ijvm. it uses the top two values on the stack, replacing the two with a single value, the result. the sec- ond-from-top word of the stack is the operand to be shifted. its content is shifted left by a value between 0 and 31, inclusive, depending on the value of the 5 least signifi- cant bits of the top word on the stack (the other 27 bits of the top word are ignored). zeros are shifted in from the right for as many bits as the shift count. the opcode for ishl is 120 (0x78).a. what is the arithmetic operation equivalent to shifting left with a count of 2? b. extend the microcode to include this instruction as a part of ijv.

When is a chart legend used a. all the time b. whenever you are comparing data that is the same c. whenever you are comparing multiple sets of data d. only for hand-drawn charts