What are the three secondary colors found on the color wheel

3. (6 pts) internally in the computer, with few exceptions, all numerical computation is done using binary numbers. output, however, often uses ascii, which is formed by appending 011 to the left of a bcd code. thus, an algorithm that directly converts a binary integer to a bcd integer is very useful. here is one such algorithm 1) draw lines to the left of the binary number to bound the expected bcd decades. (each decade is a group of 4 bits.) move the binary number one bit to the left. add 0011 to each bcd decade containing a binary value> 0100 repeat steps 2-3 until the last bit in the binary number has been moved into the least significant decade position. (note that when the last bit has been shifted into bcd decade, step 3 is not repeated.) read the bcd result. 2) 3) 4) 5) a) execute the algorithm for the binary number 1101101 b) execute the algorithm for the binary number 01110101110 4. (4 pts) represent the decimal number 3568 in bcd; excess-3 code; ascil; and hex.

Answer the following questions regarding your system by using the commands listed in this chapter. for each question, write the command you used to obtain the answer. a. what are the total number of inodes in the root filesystem? how many are currently utilized? how many are available for use? b. what filesystems are currently mounted on your system? c. what filesystems are available to be mounted on your system? d. what filesystems will be automatically mounted at boot time?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.