Computers and Technology, 22.07.2020 01:01, princeofpowerjr
The first electric, general-purpose computer, ENIAC, was programmed by calculating algorithms on paper entering code directly into the computer flipping switches by hand using MS-DOS as the operating system
Answers: 2
Computers and Technology, 21.06.2019 22:00, karena13aguirre
Problems: 1. using textbooks, reference books, and internet as your source of research, draw the following microprocessor microarchitectures i. intel 8086 ii. motorola 68000 i atmel atmega32 iv. mips single cycle v. arm cortex-m3 write an hdl module for a hexadecimal seven-segment display decoder. the input is 4-bit binary representing a hex number (0-f), and the output is 8-bit seven segment display bits (a-h). thus, the decoder must handle the digits 10 - 15 to display a-f respectively, in addition to 0-9 numbers. 2. design a 4-bit left and right rotator (both outputs). first sketch schematic diagrams of your design. then implement your design using hdl coding. 3. 4. design a modified priority encoder that receives an 8-bit input, a7: 0 and produces a 3-bit output, y2o. y indicates the most significant bit of the input that is true. y should be 0 if none of the inputs are true. give a simplified boolean equation, sketch a schematic, and write an hdl code. 5.write an 8: 1 multiplexer module called mux8 with selection inputs s, data input d, and data output y. data input (d) and data output (v) are 32-bit wide
Answers: 3
Computers and Technology, 22.06.2019 08:00, razielcornils04
What is the algorithm for building a binary tree program
Answers: 2
Computers and Technology, 23.06.2019 21:10, jmolina57
Asample of 200 rom computer chips was selected on each of 30 consecutive days, and the number of nonconforming chips on each day was as follows: 8, 19, 27, 17, 38, 18, 4, 27, 9, 22, 30, 17, 14, 23, 15, 14, 12, 20, 13, 18, 14, 20, 9, 27, 30, 13, 10, 19, 12, 26. construct a p chart and examine it for any out-of-control points. (round your answers to four decimal places.)
Answers: 2
Computers and Technology, 24.06.2019 01:00, bellamyciana
What are two ways to access the options for scaling and page orientation? click the home tab, then click alignment, or click the file tab. click the file tab, then click print, or click the page layout tab. click the page layout tab, or click the review tab. click the review tab, or click the home tab?
Answers: 2
The first electric, general-purpose computer, ENIAC, was programmed by calculating algorithms on pap...
Mathematics, 29.01.2020 13:00
Mathematics, 29.01.2020 13:00
Mathematics, 29.01.2020 13:00
Mathematics, 29.01.2020 13:00
Mathematics, 29.01.2020 13:00
Social Studies, 29.01.2020 13:00