Explain why an organization's firewall should block incoming packets the destination address of which is the organization's broadcast address?

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Read the code below. what will the computer print if the input for year_variable is 1700? if year_variable == 1776: print("your answer is correct. the declaration of independence was signed in “year_variable”.") elif year_variable < 1776: compute_variable = 1776 - year_variable. print("add “compute_variable“ years to your answer for the correct answer.") elif year_variable > 1776: compute_variable = year_variable - 1776 print("subtract “compute_variable” years from your answer for the correct answer.")

The instruction ishl (shift left integer) exists in jvm but not in ijvm. it uses the top two values on the stack, replacing the two with a single value, the result. the sec- ond-from-top word of the stack is the operand to be shifted. its content is shifted left by a value between 0 and 31, inclusive, depending on the value of the 5 least signifi- cant bits of the top word on the stack (the other 27 bits of the top word are ignored). zeros are shifted in from the right for as many bits as the shift count. the opcode for ishl is 120 (0x78).a. what is the arithmetic operation equivalent to shifting left with a count of 2? b. extend the microcode to include this instruction as a part of ijv.