Computers and Technology, 26.06.2020 15:01, tamya12234
When implementing a physical database from a logical data model, you must consider database performance by allowing data in the database to be accessed more rapidly. In order to increase data availability, the DBA may break up data that are accessed together to be stored together. Which method will improve the performance of this structure when running queries? What are advantages and disadvantages of this method?
Answers: 3
Other questions on the subject: Computers and Technology
Computers and Technology, 22.06.2019 03:00, Jadaflournoy5
Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.
Answers: 3
Computers and Technology, 22.06.2019 03:10, brylove603
Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it must not appear in the factorization. sample runs are given below. note that if the power of a prime is 1, then that 1 must appear in t
Answers: 3
Computers and Technology, 23.06.2019 21:40, gaby06
Simon says is a memory game where "simon" outputs a sequence of 10 characters (r, g, b, y) and the user must repeat the sequence. create a for loop that compares the two strings. for each match, add one point to user_score. upon a mismatch, end the game. sample output with inputs: 'rrgbryybgy' 'rrgbbrybgy'
Answers: 3
Do you know the correct answer?
When implementing a physical database from a logical data model, you must consider database performa...
Questions in other subjects:
Mathematics, 26.03.2020 19:26
Mathematics, 26.03.2020 19:26
