Study the original and changed passages. Original passage: One way to make a document more readable is by controlling the space between paragraphs, which can be done by adding space between and after a paragraph. Another way to make a document more readable is by keeping the paragraph on one page, which can be done by changing the spaces between the lines in the paragraph. Which change was applied to the original paragraph? The space between the lines of both paragraphs increased. The space between the lines of both paragraphs decreased. The space between paragraphs 1 and 2 increased. The space between paragraphs 1 and 2 decreased.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."