Computers and Technology
Computers and Technology, 19.05.2020 22:14, Eddie997

Which three statements about RSTP edge ports are true? (Choose three.) Group of answer choices If an edge port receives a BPDU, it becomes a normal spanning-tree port. Edge ports never generate topology change notifications (TCNs) when the port transitions to a disabled or enabled status. Edge ports can have another switch connected to them as long as the link is operating in full duplex. Edge ports immediately transition to learning mode and then forwarding mode when enabled. Edge ports function similarly to UplinkFast ports. Edge ports should never connect to another switch.

answer
Answers: 2

Other questions on the subject: Computers and Technology

image
Computers and Technology, 23.06.2019 00:50, AmbitiousAndProud
Representa os dados de um banco de dados como uma coleç? o de tabelas constituídas por um conjunto de atributos, que definem as propriedades ou características relevantes da entidade que representam. marque a alternativa que representa o modelo descrito no enunciado. escolha uma:
Answers: 3
image
Computers and Technology, 23.06.2019 11:30, magicalpenguin48
In cell h5 enter a formula that will calculate the percentage of attendees that went to the altamonte springs job fair in 2018.
Answers: 1
image
Computers and Technology, 23.06.2019 12:00, anamatiascamaja
If you embed a word table into powerpoint, what happens when you make edits to the embedded data? a. edits made to embedded data change the data in the source file; however, edits made to the source file will not be reflected in the embedded data. b. edits made to embedded data will change the data in the source file, and edits made to the source file will be reflected in the embedded data. c. edits made to embedded data don't change the data in the source file, nor will edits made to the source file be reflected in the embedded data. d. edits made to embedded data don't change the data in the source file; however, edits made to the source file will be reflected in the embedded data.
Answers: 1
image
Computers and Technology, 23.06.2019 15:30, jasssp
Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to
Answers: 2
Do you know the correct answer?
Which three statements about RSTP edge ports are true? (Choose three.) Group of answer choices If an...

Questions in other subjects:

Konu
Health, 10.04.2021 17:40
Konu
Chemistry, 10.04.2021 17:40
Konu
Social Studies, 10.04.2021 17:40