Have a look at the lines of code below. Over the next 3 questions, we will write code that opens a file

named MyName. txt, read the first line from the file MyName. txt and display it, and then close it.

What should line number 20 be? The aim is to open a file named MyName. txt. Enter the entire line 20 i. e. start with File file =..

20 File file = new ;

21 Scanner inputFile = new Scanner(file);

22 if (inputFile. hasNext())

23 {

24 String str =;

25 System. out. println(str);

26 }

27 ;

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

You have a linux system that has a 1000gb hard disk drive, which has a 90gb partition containing an ext4 filesystem mounted to the / directory and a 4gb swap partition. currently, this linux system is only used by a few users for storing small files; however, the department manager wants to upgrade this system and use it to run a database application that will be used by 100 users. the database application and the associated data will take up over 200gb of hard disk space. in addition, these 100 users will store their personal files on the hard disk of the system. each user must have a maximum of 5gb of storage space. the department manager has made it very clear that this system must not exhibit any downtime as a result of hard disk errors. how much hard disk space will you require, and what partitions would you need to ensure that the system will perform as needed? where would these partitions be mounted? what quotas would you implement? what commands would you need to run and what entries to /etc/fstab would you need to create? justify your answers.

What is the penalty for violating section 1201 of title 17 chapter 21 of the us code