Show the stack with all activation record instances, including static and dynamic chains, when execution reaches position 1 in the following skeletal program. Assume bigsub is at level 1.

function bigsub() {

function a() {

function b() {

... <1

} // end of b

function c() {

...

b();

...

} // end of c

...

c();

} // end of a

...

a();

...

}// end of bigsum

Consider this data sequence: "3 11 5 5 5 2 4 6 6 7 3 -8". any value that is the same as the immediately preceding value is considered a consecutive duplicate. in this example, there are three such consecutive duplicates: the 2nd and 3rd 5s and the second 6. note that the last 3 is not a consecutive duplicate because it was preceded by a 7. write some code that uses a loop to read such a sequence of non-negative integers , terminated by a negative number. when the code finishes executing, the number of consecutive duplicates encountered is printed. in this case, 3 would be printed. assume the availability of a variable, stdin, that references a scanner object associated with standard input. that is, stdin = new scanner(system. in); is given.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

You draw two cards from a standard deck of 52 cards, but before you draw the second card, you put the first one back and reshuffle the deck. (a) are the outcomes on the two cards independent? why?