Write a class that will contain: 1.) a recursive method that will calculate any base to any power 2.) call the recursive method from main, asking the user for the base and the power 3.) write the loop version of the method 4.) call the loop version from main, using the same base and power that the user supplied earlier 5.) check that both methods return the same answer 6.) measure the number of nanoseconds that each method takes, & report which version of the methods is faster. Use either System. currentTimeMillis() or System. nanoTime() to get the start and end time assigned to 2 long variables, then subtract, and that is your total time.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."