Computers and Technology, 25.03.2020 17:03, gerkera88

In the C-SCAN disk scheduling algorithm, the disk arm is required to move in one direction only until it reaches the last track or there are no more requests to service in that direction, then it reverses direction and the scan proceeds in the opposite direction in the same fashion.

True / False.

Answers: 1

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 22.06.2019 12:20, crodriguez87

Usually, when we sniff packets, we are only interested certain types of packets. we can do that by setting filters in sniffing. scapy’s filter use the bpf (berkeley packet filter) syntax; you can find the bpf manual from the internet. set the following filters and demonstrate your sniffer program again (each filter should be set separately): (a) capture only the icmp packet. (b) capture any tcp packet that comes from a particular ip and with a destination port number 23. (c) capture packets comes from or to go to a particular subnet. you can pick any subnet, such as 128.230.0.0/16; you should not pick the subnet that your vm is attached to.

Answers: 3

continue

Computers and Technology, 22.06.2019 20:30, fickllyd000

In this lab, you complete a prewritten c program that calculates an employee’s productivity bonus and prints the employee’s name and bonus. bonuses are calculated based on an employee’s productivity score as shown below. a productivity score is calculated by first dividing an employee’s transactions dollar value by the number of transactions and then dividing the result by the number of shifts worked.

Answers: 3

continue

Computers and Technology, 22.06.2019 23:30, keviongardner

The next button in the review section shows the next available comment. next slide with no comment. previous comment. edited comment.

Answers: 1

continue

Computers and Technology, 23.06.2019 15:30, jokerr6323

1. ask the user how many questions are in the quiz. 2. ask the user to enter the key (that is, the correct answers). there should be one answer for each question in the quiz, and each answer should be an integer. e. g., 34 7 13 100 81 3 9 10 321 12 might be the key for a 10-question quiz. you will need to store the key in an array. 3. ask the user to enter the answers for the quiz to be graded. there needs to be one answer for each question. note that these answers do not need to be stored; each answer can simply be compared to the key as it is entered. 4. when the user has entered all of the answers to be graded, print the number correct and the percent correct. 5. add a loop so that the user can grade any number of quizzes with a single key. after the results have been printed for each quiz, ask "grade another quiz? (y/n)." note: you only have one array (the key). you are not creating a new key for each set of quiz answers.

Answers: 3

continue

Do you know the correct answer?

In the C-SCAN disk scheduling algorithm, the disk arm is required to move in one direction only unti...