Write the definition of a function typing_speed, that receives two parameters. the first is the number of words that a person has typed (an int greater than or equal to zero) in a particular time interval. the second is the length of the time interval in seconds (an int greater than zero). the function returns the typing speed of that person in words per minute (a float).

3. (6 pts) internally in the computer, with few exceptions, all numerical computation is done using binary numbers. output, however, often uses ascii, which is formed by appending 011 to the left of a bcd code. thus, an algorithm that directly converts a binary integer to a bcd integer is very useful. here is one such algorithm 1) draw lines to the left of the binary number to bound the expected bcd decades. (each decade is a group of 4 bits.) move the binary number one bit to the left. add 0011 to each bcd decade containing a binary value> 0100 repeat steps 2-3 until the last bit in the binary number has been moved into the least significant decade position. (note that when the last bit has been shifted into bcd decade, step 3 is not repeated.) read the bcd result. 2) 3) 4) 5) a) execute the algorithm for the binary number 1101101 b) execute the algorithm for the binary number 01110101110 4. (4 pts) represent the decimal number 3568 in bcd; excess-3 code; ascil; and hex.

Plz 40 points what are raster vectors? a bitmap image a vector file a type of printing press a small projector

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.