We all use gps today, even if we don't drive yet. i bet you have been in the car with a parent and they have asked you to get out your phone to find a specific location. in your car, on the phone, you are using a very sophisticated technology. gps satellites circle the earth twice a day in a very precise orbit and transmit signal information to earth. gps receivers take this information and use trilateration to calculate the user's exact location. essentially, the gps receiver compares the time a signal was transmitted by a satellite with the time it was received. the time difference tells the gps receiver how far away the satellite is. now, with distance measurements from a few more satellites, the receiver can determine the user's position and display it on the unit's electronic map. what type of signal is utilized by the gps satellite? a) gps satellites transmit uv radiation. b) gps satellites transmit low power radio signals. c) gps satellites transmit multiple gamma wave signals. d) gps satellites transmit high powered satellite signals.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

[a] create a class called “cycle” which has two instance integer variables as properties, “numberofwheels” and “weight.” create a constructor with two parameters, using the same variable names in the parameter list. assign each variable to numberofwheels” and “weight” respectively. write a separate application to test the class and display its properties. note: do not change the names of the instance variables or the variables listed in the constructor’s parameter list. [b] edit your class cycle by adding a default constructor which will assign the default values of 100 to represent the numberofwheels, and 1000 to represent the weight, by invoking a call to the other constructor. modify your application created in [a] to test the class.

When creating a presentation in libre office impress, where does the editing of slides take place?