Computers and Technology, 11.07.2019 23:00, lovelifekristy

Which of the following is a primary cause of lo/to accidents? a) the machine was overused b) the machine or piece of equipment was not completely shut off c) the machine operating instructions were unclear d) moving equipment was blocked

Answers: 2

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 22.06.2019 16:20, mandy9386

Consider the following statements, then select one of the answers below: the signal() function shown below registers "sig_handler()" as the signal handler function for the sigkill signal, without the complexity of using when the sigkill signal is sent to a process running this code, by a user typing "kill -kill ", where the correct process id is used for to target the process, sig_handler() will be executed.

Answers: 1

continue

Computers and Technology, 22.06.2019 16:30, nxusasmangaliso1191

The most common battery cable terminal is a that provides a large surface contact area with the ability to tighten the terminal onto the battery post using a nut and bolt.

Answers: 2

continue

Computers and Technology, 22.06.2019 19:20, bob4059

1)consider the following code snippet: #ifndef book_h#define book_hconst double max_cost = 1000.0; class book{public: book(); book(double new_cost); void set_cost(double new_cost); double get_cost() const; private: double cost; }; double calculate_terms(book bk); #endifwhich of the following is correct? a)the header file is correct as given. b)the definition of max_cost should be removed since header files should not contain constants. c)the definition of book should be removed since header files should not contain class definitions. d)the body of the calculate_terms function should be added to the header file.

Answers: 1

continue

Computers and Technology, 23.06.2019 09:30, cdavis379

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

continue

Do you know the correct answer?

Which of the following is a primary cause of lo/to accidents? a) the machine was overused b) the ma...