In which case would recalibrating a thermometer be an important next step in an experiment dealing with boiling points? A) The results of several trials are all very close to each other, but they are noticeably different from the accepted value for the boiling point.

B) A small number of trials are conducted, with results quite different from each other, and with an average that is noticeably different from the accepted value.

C) A single trial is conducted, and the result is very close to the accepted value of the boiling point.

D) The results of several trials vary by a large amount, but the average is close to the accepted value for the boiling point.

Follow the steps provided in the simulation to add water to the graduated cylinder, select one of the three samples (copper, silver, or gold), set its mass to the values given in the statements below, and calculate its density. here is a summary of the steps required: add water by clicking and holding prepare a known volume of water button. until the desired volume of water has been added. if more than the desired volume is added, click the reset button. button and redo the procedure. a single click will add about 21.0 ml of water. to set the mass, click and hold weigh out metal button. until the desired amount of metal is added to the weighing pan. once the desired mass of the metal is added, release the button. transfer the metal to water and then click on calculate density button. to see how the density is calculated using water displacement to measure the volume of the solid. to save time you can approximate the initial volume of water to â±1 ml and the initial mass of the solid to â±1 g. for example, if you are asked to add 23 ml of water, add between 22 ml and 24 ml. which metals in each of the following sets will have equal density? check all that apply.