Human Body Unit Test How do the respiratory system and circulatory system interact? ( point)
In the lungs, carbon dioxide is transferred to the blood and carried by red blood cells Once it is distributed, the red blood cells
pick up oxygen and transport it back to the lungs, where is transferred to the lungs so it can be exhaled
In the lungs, oxygen is transferred to the blood and carried by red blood cells Once it is distributed the red blood cells pick up
carbon dioxide and transport it back to the lungs, where is transferred to the lungs so it can be exhaled
The respiratory system and circulatory system do not interact because the respiratory system is related to breathing and the
circulatory system is related to blood.
In the lungs, air is transferred into the blood stream, where red blood cells deliver it to the heart. The heart then separates the
oxygen and sends it to the organs, while sending the waste back to the lungs to exhale

Embryos of different species look very similar, which shows that the organisms share a ancestor.

Follow the steps provided in the simulation to add water to the graduated cylinder, select one of the three samples (copper, silver, or gold), set its mass to the values given in the statements below, and calculate its density. here is a summary of the steps required: add water by clicking and holding prepare a known volume of water button. until the desired volume of water has been added. if more than the desired volume is added, click the reset button. button and redo the procedure. a single click will add about 21.0 ml of water. to set the mass, click and hold weigh out metal button. until the desired amount of metal is added to the weighing pan. once the desired mass of the metal is added, release the button. transfer the metal to water and then click on calculate density button. to see how the density is calculated using water displacement to measure the volume of the solid. to save time you can approximate the initial volume of water to â±1 ml and the initial mass of the solid to â±1 g. for example, if you are asked to add 23 ml of water, add between 22 ml and 24 ml. which metals in each of the following sets will have equal density? check all that apply.

)benzene and toluene form nearly ideal solutions. consider an equimolar solution of benzene and toluene. at 20 °c the vapour pressures of pure benzene and toluene are 9.9 kpa and 2.9 kpa, respectively. the solution is boiled by reducing the external pressure below the vapour pressure. calculate (i) the pressure when boiling begins, (ii) the composition of each component in the vapour, and (iii) the vapour pressure when only a few drops of liquid remain. assume that the rate of vaporization is low enough for the temperature to remain constant at 20 °c.