Chemistry, 10.01.2020 14:31, Bleejones00

The greatest difference in magnifying power is between
a.
dissecting microscopes and compound light microscopes
b.
transmission electron microscopes and dissecting microscopes
c.
scanning electron microscopes and transmission electron microscopes
d.
compound light microscopes and scanning electron microscopes

Answers: 1

Show answers

Other questions on the subject: Chemistry

Chemistry, 21.06.2019 23:00, brethan

How manyatoms of mercury are in 1.4214e+1 ml sample

Answers: 1

continue

Chemistry, 22.06.2019 08:30, vanessadaniellet21

Since the gas in your graduated cylinder is a mixture of butane and water vapor, you must determine the partial pressure of the butane, pbutane, alone. to do this, consult a reference and record the partial pressure of the water vapor, pwater, at the temperature you recorded. use the following formula to compute the partial pressure of the butane. pbutane = atmosphere - pwater use the following combined gas law formula and compute the volume that the butane sample will occupy at stp. (hint: convert both temperatures to kelvin.) pbutane x voriginal = pstandard x vfinal troom tstandard use the following ratio and proportion formula to determine the mass of butane needed to occupy a volume of 22.4 l at stp. grams of butane you used “x” grams of butane ml of butane corrected to stp = 22,400 ml compute the theoretical molar mass of butane based on its formula and the atomic masses on the periodic table. compare your experimental results from #3 to the theoretical value of #4, computing a percent error of your findings using this formula: % error = measured value - accepted value x 100 accepted value use the following ratio and proportion formula to determine the mass of butane needed to occupy a volume of 22.4 l at stp. need asap

Answers: 1

continue

Chemistry, 22.06.2019 12:30, masteroftheuniverse3

When a scientific theory has been tested and proved by the scientific community, it becomes a law

Answers: 2

continue

Chemistry, 22.06.2019 17:30, destineysarah

98 points you will be galileo perform the experiment to determine if objects with different mass fall at the same, or different, rates in the air and in a vacuum. before you conduct your experiment, you need to form a hypothesis. a hypothesis is a prediction of what you think will happen in the experiment. the hypothesis is a statement that describes “if” a certain set of circumstances are present “then” there will be a specific result that will occur. record your hypothesis here: record the results from step one of the experiment (dropping the objects in the air): first trial: second trial: third trial: record the results from step two of the experiment (dropping the objects in a vacuum): first trial: second trial: third trial: did the experiment support your hypothesis? using the data from your experiment, describe why you believe your hypothesis was either proven or disproven. what forces were acting on the objects dropped in the air? what force was acting on the objects dropped in the vacuum? part two: comparing forces choose two forces and compare and contrast these forces. you must provide two ways that they are alike and two ways that they are different. you may make a list, write in paragraph form, or make a chart. choose two forces and compare and contrast these forces. these must be different forces than used in the prior question. provide two ways that they are similar and two ways that they are different. you may make a list, write it out, or make a chart.

Answers: 3

continue

Do you know the correct answer?

The greatest difference in magnifying power is between
a.
dissecting microscopes and co...