Chemistry, 27.02.2021 06:10, hernandezbrandon059

PLEASE HELP WITH BOTH QUESTIONS ASAP ILL MARK U BRAINLIST

Answers: 3

Show answers

Other questions on the subject: Chemistry

Chemistry, 22.06.2019 01:30, josephaciaful

Follow the steps provided in the simulation to add water to the graduated cylinder, select one of the three samples (copper, silver, or gold), set its mass to the values given in the statements below, and calculate its density. here is a summary of the steps required: add water by clicking and holding prepare a known volume of water button. until the desired volume of water has been added. if more than the desired volume is added, click the reset button. button and redo the procedure. a single click will add about 21.0 ml of water. to set the mass, click and hold weigh out metal button. until the desired amount of metal is added to the weighing pan. once the desired mass of the metal is added, release the button. transfer the metal to water and then click on calculate density button. to see how the density is calculated using water displacement to measure the volume of the solid. to save time you can approximate the initial volume of water to â±1 ml and the initial mass of the solid to â±1 g. for example, if you are asked to add 23 ml of water, add between 22 ml and 24 ml. which metals in each of the following sets will have equal density? check all that apply.

Answers: 1

continue

Chemistry, 23.06.2019 02:20, theactualslash

In a chemical reaction, the final amount of the products is determined by the a. universal gas law b. law of definite proportions c. air pressure d. temperature e. none of the above me

Answers: 2

continue

Chemistry, 23.06.2019 03:00, Wavy10691

Asample of sea water contains 6.28g of sodium chloride per litre of solution. how many milligrams of sodium chloride would be contained in 15.0ml of this solution?

Answers: 3

continue

Chemistry, 23.06.2019 06:00, hopechinn6646

Complete the sentences to best explain the ranking. match the words below to the appropriate blanks in the sentences. a less polar bondhigher molar massion-dipole forcesstronger intermolecular forcesdipole-dipole forcesdispersion forceshydrogen bonding1. h2s and h2se exhibit the following intermolecular forces:.2. therefore, when comparing h2s and h2se the one with a has a higher boiling point .3. the strongest intermolecular force exhibited by h2o is . therefore, when comparing h2se and h2o the one with has a higher boiling point.

Answers: 1

continue

Do you know the correct answer?

PLEASE HELP WITH BOTH QUESTIONS ASAP ILL MARK U BRAINLIST
...