Some chemical reactions need energy in the form of heat to take place, while others give off energy. Read each of the phrases that describe endothermic or exothermic reactions and select the type of reaction the description represents. it is either endothermic or exothermic reaction for all

1.some energy is released as light
[ Select ]
2.energy released is greater than the energy needed to break bonds
[ Select ]
3.need continuous source of energy
[ Select ]
4.leaves the surroundings feeling cold
[ Select ]
5.some energy is released as heat
[ Select ]
6.more energy needed to break bonds of the the reactants than is released
[ Select ]

Follow the steps provided in the simulation to add water to the graduated cylinder, select one of the three samples (copper, silver, or gold), set its mass to the values given in the statements below, and calculate its density. here is a summary of the steps required: add water by clicking and holding prepare a known volume of water button. until the desired volume of water has been added. if more than the desired volume is added, click the reset button. button and redo the procedure. a single click will add about 21.0 ml of water. to set the mass, click and hold weigh out metal button. until the desired amount of metal is added to the weighing pan. once the desired mass of the metal is added, release the button. transfer the metal to water and then click on calculate density button. to see how the density is calculated using water displacement to measure the volume of the solid. to save time you can approximate the initial volume of water to â±1 ml and the initial mass of the solid to â±1 g. for example, if you are asked to add 23 ml of water, add between 22 ml and 24 ml. which metals in each of the following sets will have equal density? check all that apply.

Weight is a measure of: inertia force matter mass

Where are the noble gases located in the periodic table? a. in the center b. on the left side c. in the upper right corner d. on the far right side