Perform the following pressure conversions, assuming when necessary that atmospheric pressure is 1 atm. Unless otherwise stated, the given pressures are absolute. ENVIRONMENTAL 78 CHAPTER 3 Processes and Process Variables (a) 2600 mm Hg to psi (b) 275 ft H2O to kPa (c) 3.00 atm to N/cm2 (d) 280 cm Hg to dyne/m2 (e) 20 cm Hg of vacuum to atm (absolute) (f) 25.0 psig to mm Hg (gauge) (g) 25.0 psig to mm Hg (absolute) (h) 325 mm Hg to mm Hg gauge (i) 45.0 psi to cm of carbon tetrachloride

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.

the answer is:  

line graphs show patterns in data with variables that change over time; whereas, circle graphs show data as parts out of a whole (such as out of 100%).