A student states, "When the alcohol sample was at a temperature of 500 K, all the particles were moving faster than any of the particles were moving at 400 K." Do you agree or disagree with this student’s statement? Justify your answer

This is very true

Explanation:

The kinetic energy in a system is directly proportional to the temperature of a system.

The higher the temperature, the faster the particles of a system will move. From the kinetic molecular theory, we see that the temperature of a system is a measure of the average kinetic energy of the molecules.

In chemical kinetics, as the temperature increases, the kinetic energy of the system also increases.

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.

a saline water is fed to a reverse osmosis unit at flow rate o rotameter connected to reject (retentate) line reads 8 installed in reject and permeate line reads 15.2 milli siemens/cm and 300 micro siemens/com respectively.