Chemistry, 22.12.2020 20:50, chasewilkinson123

Need help with this.

Answers: 3

Show answers

Answers

answered: CoolBro92

18.2 g.

Explanation:

You need to first figure out how many moles of nitrogen gas and hydrogen (gas) you have. To do this, use the molar masses of nitrogen gas and hydrogen (gas) on the periodic table. You get the following:

0.535 g. N2 and 1.984 g. H2

Then find out which reactant is the limiting one. In this case, it's N2. The amount of ammonia, then, that would be produced is 2 times the amount of moles of N2. This gives you 1.07 mol, approximately. Then multiply this by the molar mass of ammonia to find your answer of 18.2 g.

answered: Guest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

answered: Guest

Read the sentences below in 1962, i tried to enroll as the first black student at the university of mississippi. the governor of mississippi blocked my entrance which best describes the verbs used in the sentences? o they are past tense verbs, which are often used in narrative essays o they are past tense verbs, which are not often used in narrative essays. o they are future tense verbs, which are often used in narrative essays o they are future tense verbs, which are not often used in narrative essays.

Other questions on the subject: Chemistry

Chemistry, 22.06.2019 06:00, ehhshsh

Calculate the mass of silver needed to react with chlorine to produce 126g if silver chloride?

Answers: 3

continue

Chemistry, 22.06.2019 10:10, andersonemma2222

How do you identify the anode on a power source such as a battery? how do you identify the cathode? how are terms anion and cation?

Answers: 1

continue

Chemistry, 22.06.2019 19:50, nikoidurrant

What is the wavelength of a wave with a velocity of 50 m/s and a frequency of 5hz a 250 m b 0.1 m c 10m d 0.01 m

Answers: 2

continue

Chemistry, 22.06.2019 20:10, jakhunter354

The lattice enthalpy (formation of ionic solid from ions in the gas phase) for agcl(s) is -916 kj/mol and the hydration enthalpy (dissolution of gaseous ions into water) is -850 kj/mol. how much heat (in joules) is involved in forming 1l of saturated agcl solution (1.8 × 10-4 g / 100 ml water) by dissolving agcl(s)? assume solution volume does not change much upon dissolution. the equations are given below. ag+(g) + cl−(g) æ agcl(s)

Answers: 3

continue

Do you know the correct answer?

Need help with this.
...