Chemistry
Chemistry, 08.12.2020 04:10, anniebear

PLEASE HELP! Assignment: Edmentum, Course Activity: Oxidizing and Reducing Chemicals. Questions Below PART B
Observe and record the appearances of the metal strips and the solutions in the test tubes.
Magnesium-
Zinc-
Copper-
Zinc Nitrate-
Magnesium Nitrate-
Copper (II) NIitrate-
Part C
Place the copper strips in test tubes 3 and 6. If the strips are too wide, you may bend them to fit them in the test tubes.

Place the magnesium strips in test tubes 1 and 4. If necessary, use the stirring rod to push the strips down until they’re entirely submerged.

Place the zinc strips in test tubes 2 and 5.

Record your observations of the appearance of the substances in the test tubes immediately after adding the metal strips. Include any evidence of a chemical reaction. If there’s no evidence of a reaction, write “no reaction.”

1-
2- no reaction
3- no reaction
4-
5-
6-

PART D
After about 30 minutes, observe the substances in the test tubes again. Record your observations. Include any evidence of a chemical reaction.
1-
2-
3-
4-
5-
6-
PART E
Leave the test tubes for about 24 hours. Then observe the metal strips in the test tubes again. Record your observations. Include any evidence of a chemical reaction.
1-
2-
3-
4-
5-
6-

PART F
In the original mixtures, test tube 1 contained magnesium and a zinc compound, and test tube 2 contained zinc and a magnesium compound. A similar relationship exists between test tubes 3 and 4 and between test tubes 5 and 6. Compare what took place in each corresponding pair of test tubes. What general conclusion can you draw?

TASK 2
EXTRA INFO
Test tube 1 mass was .38g to begin with and now is .49g. Test Tube 5 mass was 3.53g to begin with and now is 3.78g.
PART B
Compare the mass of the magnesium strip from test tube 1 with the initial mass of the same strip measured in task 1, part A. Is the mass the same, or is it different? If it’s different, explain what may have caused the difference.

PART C
Compare the mass of the zinc strip from test tube 5 with the mass of the same strip measured in task 1, part A. Based on your observations of the metal strip, explain what factors may have added to its mass or caused a decrease in its mass. Which had the greater effect? Explain your reasoning.

PART D
What evidence can be used to support the fact that oxidation, reduction, or both took place in test tube 5?

TASK 3
PART A
Copper atoms are heavier than magnesium atoms. So, although each atom of magnesium can produce one atom of copper, the masses won’t be the same. The ratio of the atomic weight of copper to the atomic weight of magnesium is about 2.61. Given this ratio and the initial mass of the magnesium strip measured in task 1, part A, calculate the mass of copper that can be produced. Recall: Mg + Cu(NO3)2 → Cu + Mg(NO3)2

PART C
Compare the amount of copper predicted in part A with the amount measured in part B. What percentage of the predicted amount was obtained? Why aren’t these values the same?

answer
Answers: 1

Other questions on the subject: Chemistry

image
Chemistry, 22.06.2019 10:00, nana54muller
Part 1: include important facts found through your research. part 2: include your visual display. include your summary of “the chemistry of water” from the national science foundation website. include your experiment. part 3: include responses to the reflection questions.
Answers: 1
image
Chemistry, 22.06.2019 15:00, alanmarcus22
What does the symbol (–hfus) indicate in a phase change?
Answers: 1
image
Chemistry, 22.06.2019 19:30, Kianna000
What is the area in square meters of 448 g ai foil that has a thickness of 23921 nm? the density is 2.70 g/cm
Answers: 3
image
Chemistry, 23.06.2019 13:00, fsyeda550
If volume remains the same while the mass of a substance the density of the substance
Answers: 1
Do you know the correct answer?
PLEASE HELP! Assignment: Edmentum, Course Activity: Oxidizing and Reducing Chemicals. Questions Belo...

Questions in other subjects:

Konu
Mathematics, 19.04.2021 20:30