Chemistry, 26.10.2020 18:20, nevaeh33cx

Another Question.

Another Question......

Answers: 3

Show answers

Answers

answered: Guest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

answered: Guest

The answers is bad germs in their

answered: Guest

a 20-cm-long, cylindrical graphite (pure carbon) rod is inserted into an oxidizing atmosphere at 1145 k and 1.013 x 105 pa pressure. the oxidizing process is limited by the diffu- sion of oxygen counterflow to the carbon monoxide that is formed on the cylindrical surface.

answered: Guest

There is no reason to think the results are biased or not conducted properly but you should not assume the results are correct just because they were done in a laboratory so the answer would be c. it is likely to be reliable because the results support the conclusion presented.

Other questions on the subject: Chemistry

Chemistry, 22.06.2019 07:00, misspicafunpoke

Indicate whether the specified alkyl halides will form primarily substitution products, only elimination products, both substitution and elimination products, or no products when they react with sodium methoxide. 1-bromobutane 1-bromo-2-methylpropane 2-bromobutane 2-bromo-2-methylpropane

Answers: 2

continue

Chemistry, 22.06.2019 10:30, ntrann22

Astudent reacts 13 moles of iron with 21 moles of oxygen according to the following equation:

Answers: 2

continue

Chemistry, 22.06.2019 12:00, ctyrector

Give the set of reactants (including an alkyl halide and a nucleophile) that could be used to synthesize the following ether: draw the molecules on the canvas by choosing buttons from the tools (for bonds and charges), atoms, and templates toolbars, including charges where needed. ch3ch2och2ch2chch3 | ch3

Answers: 1

continue

Chemistry, 22.06.2019 14:10, roserose3098

16. in a reaction that has reached equilibrium, a. the forward and reverse reactions are occurring at the same rate. b. the reactants and products are in equal concentrations. c. the forward reaction has gone further than the reverse reaction. d. there are equal numbers of atoms on both sides of the equation. e. a, b, and d are correct.

Answers: 2

continue

Do you know the correct answer?

Another Question.
...