Chemistry, 22.09.2020 14:01, hemaam8

During studies of the following reaction (i), a chemical engineer measured a less-than-expected yield of N2 and discovered that the following side reaction (ii) occurs. (i) N2O4(l) 2 N2H4(l) 3 N2(g) 4 H2O(g) (ii) 2 N2O4(l) N2H4(l) 6 NO(g) 2 H2O(g) In one experiment 12.7 g of NO formed when 101.1 g of each reactant was used. What is the highest percent yield of N2 that can be expected

Answers: 1

Show answers

Other questions on the subject: Chemistry

Chemistry, 22.06.2019 08:30, vanessadaniellet21

Since the gas in your graduated cylinder is a mixture of butane and water vapor, you must determine the partial pressure of the butane, pbutane, alone. to do this, consult a reference and record the partial pressure of the water vapor, pwater, at the temperature you recorded. use the following formula to compute the partial pressure of the butane. pbutane = atmosphere - pwater use the following combined gas law formula and compute the volume that the butane sample will occupy at stp. (hint: convert both temperatures to kelvin.) pbutane x voriginal = pstandard x vfinal troom tstandard use the following ratio and proportion formula to determine the mass of butane needed to occupy a volume of 22.4 l at stp. grams of butane you used “x” grams of butane ml of butane corrected to stp = 22,400 ml compute the theoretical molar mass of butane based on its formula and the atomic masses on the periodic table. compare your experimental results from #3 to the theoretical value of #4, computing a percent error of your findings using this formula: % error = measured value - accepted value x 100 accepted value use the following ratio and proportion formula to determine the mass of butane needed to occupy a volume of 22.4 l at stp. need asap

Answers: 1

continue

Chemistry, 22.06.2019 20:50, kris1920

What is the vapor pressure of a solution with a benzene to octane?

Answers: 2

continue

Chemistry, 22.06.2019 23:00, liv467

Which of your 24 wells had indications that a chemical reaction occurred? how were you able to tell that a chemical reaction occurred? which of your 24 wells had indications that a physical reaction occurred? how were you able to tell that a physical reaction occurred? report on both mixing and evaporation. make a general statement about whether your hypotheses were validated or rejected. must your hypotheses be correct for this to be a successful laboratory?

Answers: 3

continue

Chemistry, 23.06.2019 02:00, jyow6688

The plant food contains nh4)3po4 what tests would you run to verify the presence of the nh4 ion and the po4 ion

Answers: 2

continue

Do you know the correct answer?

During studies of the following reaction (i), a chemical engineer measured a less-than-expected yiel...