Chemistry
Chemistry, 03.04.2020 22:33, YwnDerek

The picture above shows a frying pan. Why are frying pans usually made out of metal?
A.
because metal is a good conductor of heat
B.
because metal is a good conductor of electricity
C.
because metal is a poor conductor of heat
D.
because metal is a poor conductor of electricity

answer
Answers: 2

Other questions on the subject: Chemistry

image
Chemistry, 22.06.2019 06:00, giusto1894
24. a sports ball is inflated to an internal pressure of 1.85 atm at room temperature (25 °c). if the ball is then played with outside where the temperature is 7.5 °c, what will be the new pressure of the ball? assume the ball does not change in volume nor does any air leak from the ball a) 0.555 atm b) 1.74 atm c) 1.85 atm d) 1.97 atm
Answers: 2
image
Chemistry, 22.06.2019 07:30, jyworthy
Aradio signal from a gps satellite take only about 0.067 seconds to reach a gps reciever. if the speed of light is about 300,000km/s, then approximately how far away is the reciever from from the satellite?
Answers: 1
image
Chemistry, 22.06.2019 08:30, microwave13016
Agroup of students is studying convection current. they fill two identical balloons with the same amount of helium. one balloon is placed in a freezer and the other is in an area with warm air. after 10 minutes, the balloon are released from a height of 1 meter. which of the following to the students most likely observe? a) the warm balloon expands and rises. the cold balloon shrinks and sinks b) the balloon both rise. the cold balloon is larger than the warm balloon c) the cold balloon expands and rises. the warm balloon shrinks and sinks d) the balloon rise at the same rate. both balloons are the same size
Answers: 1
image
Chemistry, 22.06.2019 12:30, volocibel
Consider the four elements above. which one of these elements will combine with oxygen in a 1: 1 ratio?
Answers: 3
Do you know the correct answer?
The picture above shows a frying pan. Why are frying pans usually made out of metal?
A.
...

Questions in other subjects:

Konu
Computers and Technology, 13.01.2020 11:31