What are some safety precautions that must be taken in order for nuclear reactions to occur? give at least 5 precautions

1. Control of Radioactivity

This requires being able to control the neutron flux. Recall that in a nuclear reactor when a neutron is captured by a fuel nucleus (generally uranium) the nucleus splits releasing radioactive particles (or undergoes fission). Hence if we decrease the neutron flux we decrease the radioactivity. The most common way to reduce the neutron flux is include neutron-absorbing control rods. These control rods can be partially inserted into the reactor core to reduce the reactions. The control rods are very important because the reaction could run out of control if fission events are extremely frequent. In modern nuclear power plants, the insertion of all the control rods into the reactor core occurs in a few seconds, thus halting the nuclear reaction as rapidly as possible. In addition, most reactors are designed so that beyond optimal level, as the temperature increases the efficiency of reactions decreases, hence fewer neutrons are able to cause fission and the reactor slows down automatically.

2. Maintenance of Core Cooling

In any nuclear reactor some sort of cooling is necessary. Generally nuclear reactors use water as a coolant. However some reactors which cannot use water use sodium or sodium salts.

3. Maintenance of barriers that prevent the release of radiation

There is a series of physical barriers between the radioactive core and the environment. For instance at the Darling Nuclear Generation Station in Canada the reactors are enclosed in heavily reinforced concrete which is 1.8m thick. Workers are shielded from radiation via interior concrete walls. A vacuum building is connected to the reactor buildings by a pressure relief duct. The vacuum building is a 71m high concrete structure and is kept at negative atmospheric pressure. This means that if any radiation were to leak from the reactor it would be sucked into the vacuum building and therefore prevented from being released into the environment.

The design of the reactor also includes multiple back-up components, independent systems (two or more systems performing the same function in parallel), monitoring of instrumentation and the prevention of a failure of one type of equipment affecting any other.

Further, regulation requires that a core-meltdown incident must be confined only to the plant itself without the need to evacuate nearby residence.

Safety is also important for the workers of nuclear power plants. Radiation doses are controlled via the following procedures,

The handling of equipment via remote in the core of the reactor

Physical shielding

Limit on the time a worker spends in areas with significant radiation levels

Monitoring of individual doses and of the work environment

- calcium has greater affinity to bond with electron receptors than hydrogen does and hence, it has the ability to replace hydrogen in most of its compounds.

- lithium has 2 valence electrons in the product because it can make only 1 bond with hydrogen. beryllium has 4 valence electrons in the product because it can only make 2 bonds. it has fewer electrons than neon and can react with electron donors. each hydrogen has 2 valence electrons, the same as helium.

- the covalent bond formed between carbon and hydrogen is polar because carbon is more electronegative than hydrogen and it attracts the bonded electron pair closer to itself, thus giving hydrogen a partial positive charge.

- a hydrogen bond is a relatively weak bond that hydrogen atoms make with the electronegative atoms nitrogen, oxygen or fluorine.

so the best choice is a.) 2 calcium (ca) atoms

answer : one can design an experiment using a liquid and an additive that can be added to the liquid and observe the chemical changes in the reaction species.

one would need a beaker which is filled with a known amount of the liquid in which thermometer is placed to measure the temperature changes; after addition of the additive to the liquid solution one can note down the temperature change and find whether the reaction is endothermic or exothermic in nature. by subtracting the initial temperature value with the final temperature one can find the temperature changes.

various combinations of liquid and additive can be used. liquid in this case can be a known quantity of water and additives can be epsom salt or without epsom salt the experiment can be conducted to notice the changes. water and ice, hydrogen peroxide and dry yeast, vinegar and baking soda,etc.